Scope mounting

Mounting the laser to a rifle is very simple on telescopic sights. Having the laser mounted to the scope gives the option of using either sight.

Undo the mount and place it over the barrel of the scope and re-insert the screw. Place the laser in the mount, rotate the laser until the alignment notch is verticle at the top. We suggest you mount it midway along the laser barrel. The laser should be fixed as close to the line of the barrel as possible without touching the stock. Once in position tighten the middle screw, then the outside screw firmly. To attach the pressure switch, tape the pressure pad on the pistol grip so you can activate the switch with your thumb and still operate the trigger. To sight the laser, simply place the crosshairs of your scope on a target and zero the dot to the centre of the crosshairs. The laser will be dead accurate if the scope is zeroed at this range.

Barrel mounting for Rifles or Shotguns

These mounts all fit underneath the barrel. Sighting instructions are the same as scope mounting.

With some semi-auto shotguns the barrel moves into the stock when fired, eg Brownings and Franchi, to prevent damage please ensure the laser is mounted further forward of the barrel.

A full range of barrel mounts are available through stockists.

2 Year Warranty

Our Laser Sights carry a 2 year warranty from the date of purchase against original defects in material and/or workmanship, provided, however that the unit has not been abused, taken apart or tampered with in any way whatsoever. The warranty is limited to the original purchaser.

In the event of a unit failure, the unit will be either repaired or replaced at the discretion of the warrantor.